javads2aa نوشته است:
دوستان سلام میتونید برام از قسمت سیم های c1و p1 یه ولتاژ گیری برام بکنید شرمنده ابزار دم دستم نیست فعلا
قسمت P1,P2 گیرنده دستگاه هستند. پایه 6 آیسی 3 که همون فرستنده C1 هست از لحاظ تئوری باید بین 4+ و 4- ولتاژش در نوسان باشه.
The non-inverting input (pin 3) of IC3 is
connected to one of the PIC microcontroller’s
output pins (RA2) and is fed with
a 137Hz square wave, generated by the
software, and which alternates between
+5V and 0V. As this square wave repeatedly
crosses above and below the 2·5V reference
voltage, IC3’s comparator action
takes place and its output (pin 6) alternates
between the device’s upper and lower voltage
limits, i.e. swinging between about
+4V and –4V.
صفحه سوم مقاله "
earth resistivity logger john becker"